Fan Duct Upgrade Tests
© David Richeson
Upgraded fan duct I download and printed for my QIDI TECH 1, these reaches both extruders.
New Colours!
© David Richeson
Gold, Green, White, and Clear Filament from Spool3D. I attached the filament guild I printed earlier.
Gear For Mikes Printer
© David Richeson
A gear replacement for a laser printer that Mike had. I scanned the gear on my flat bed scanner, then traced it in 2D, then extruded it to 3D.
Thumb Drive and SD Card Organizer
© David Richeson
An original 3D design I did to hold my SD cards and Thumb Drives. I uploaded it to Thingiverse if you want to print one. – https://www.thingiverse.com/thing:2529673
Mayan Print From Drawing
© David Richeson
3D test print I did of a Mayan drawing I did created, extruded to 3D, and then printed it!
QiDi Tech 1 Spool Guide
© David Richeson
Downloaded and printed an upgrade for my QiDi Tech 1 – a filament spool guide. https://www.thingiverse.com/thing:1463485
I printed this with my first raft, don’t think I needed it though.
3D Guitar Pick Design
© David Richeson
3D Guitar Pick Design I did and nice first layers. SHS SlaughterHouse Studios – Greg trying it out!
3D Printed Owl
© David Richeson
3D Printed Owl I downloaded from Thingiverse – https://www.thingiverse.com/thing:2125599
3D Printer 1st Prints
© David Richeson First Prints with my new 3D Printer – QiDi Tech 1 I started using the stock fan duct and the right extruder with supplied orange filament. The prints did not look so nice on the right side where the fan duck could not reach to cool that side of the model. I…
Colorful Clouds
© David Richeson
wip ~ Acrylic on Canvas: Mars
© David Richeson
Banff with Auntie
A great time Lakeside camping at Two Jack !